dano Posted June 20, 2012 Share Posted June 20, 2012 Having some problems with the wall join tool (using Vectorworks 2010). Walls autojoin, but often do not heal correctly. For example, when joining 2 walls with the 'L join mode', the walls join, but a line remains, as if one wall is butting another. This occurs whether walls caps are on or off. Fiddling with the walls sometimes but not always solves the problem: ie pulling the walls back from each other and then re-joining. Any suggestions? Quote Link to comment
Dieter @ DWorks Posted June 20, 2012 Share Posted June 20, 2012 You have the end cap mode on. You can choose T, L or X mode, but besides that, you can choose to use a cap or not. It's the last two mode buttons. Quote Link to comment
dano Posted June 20, 2012 Author Share Posted June 20, 2012 thanks. I thought it must be something simple. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.