beanus Posted December 20, 2011 Share Posted December 20, 2011 since installing version 2012 I'm having problems with the number of prints vctorworks produces, if I tell it to print a single copy I get one copy but if I try to print two copies I get four copies and so on - any one else had a similar problem. The plotter I use is a Designjet 500. This problem only happens with vectorworks. Also when GDI+Imaging is turned on I can only print a single copy whatever number I try to print. Quote Link to comment
Bryan G. Posted December 21, 2011 Share Posted December 21, 2011 have not experienced this. I also have a 500. I will play with it and report back. Are you printing from Design Layer or Sheet Layer? Quote Link to comment
mcochran Posted December 21, 2011 Share Posted December 21, 2011 I am having problems getting drawings to print to designjet 500 from VW2012. One particular drawing refused to print at all and would eventually crash VW. I removed some of the geometry and it is printing now however it took about 20 minutes. I have not had these issues in the past. Windows 7 pro 64 Quote Link to comment
John Meunier Posted December 21, 2011 Share Posted December 21, 2011 A work around might be to print to PDF first. Then print the PDF file to the Designjet500. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.