Aligning component based textures.....?

[VincentCuclair]

Is there a way to get textures applied to Wall Components to align with one another?

[Horst M.]

It is possible to adjust the texture with the

Horizontal and Vertical offset under the Render Tag in the OIP.

... by typing in Numbers.

The one under the Roof in the image attached, in did with try and error.

Whenever you change something in the Wall or the Roof the alignment has to be redone.

It was much easier, to uncheck create "Gable Walls" in the Roof PIO,

and then align the Wall to the Roof.

Then it there is just one Wall under the Gable, and the alignment Problem

doesn't exist.

Edited November 20, 2011 by Horst M.

[the frog]

In the French version there is in object info, at the very bottom ?position par rapport ? une origine Z absolue?. You should have the same in your version. If you say yes then all the textures are lining up. This is necessary for the brick walls and lot of other joints.

[VincentCuclair]

Both these options don't exist for textures applied to wall components in predefined wall types........unfortunately.

Edited November 20, 2011 by Vincent C

[Dave Donley]

Hello Vincent:

We changed the wall by component behavior so that textures would line up in X, Y, and Z for 2012, not just in Z. The bug files I have look better in 2012 than in 2011 in this regard. Can you send me this file so I can debug it?