johnb Posted November 12, 2011 Share Posted November 12, 2011 Is it possible to vary the glazing bar (muntin) pattern between sashes in the same window? I have been trying to achieve the left appearance in the attached but all I can get is the right. Quote Link to comment
CipesDesign Posted November 13, 2011 Share Posted November 13, 2011 I think in 2012,if you make the top section a transom you can set the vertical and horizontal muntins specifically for the transom. Quote Link to comment
johnb Posted November 13, 2011 Author Share Posted November 13, 2011 I think in 2012,if you make the top section a transom you can set the vertical and horizontal muntins specifically for the transom. Thanks. That works for a single sash but if you have multiple sashes the transom is a single unit for the full width of the window and cannot be subdivided. Or am I missing something? Quote Link to comment
CipesDesign Posted November 13, 2011 Share Posted November 13, 2011 Good question! I am on the road with no computer to try it at the moment. Maybe someone else will chime in... Quote Link to comment
bcd Posted November 13, 2011 Share Posted November 13, 2011 Yes the transom will be the full width of the unit. The best bet may be to configure a Custom window and set the fixed number of muntins in the lower sashes only, adding them manually to the upper sashes later. If only there was more than one arrangement of muntins per sash possible, ? Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.