jgmrussell Posted November 2, 2011 Share Posted November 2, 2011 Hi, I'm still on 2010 sp4 on a mbp using Snow Leopard and for some reason I can't figure out, the page boundary does not show. It used to and I can't remember doing anything to change it etc. I do have check box for Show page boundary checked in page setup. Is there anything else I should look at? Thanks for any help. John Quote Link to comment
bc Posted November 2, 2011 Share Posted November 2, 2011 Is it possible you are simply too far zoomed in for it to show? Have you run the fit to page command? Command+4? Quote Link to comment
jgmrussell Posted November 2, 2011 Author Share Posted November 2, 2011 Thank BC. What I did was I created new document and page boundary was on that, so I just copied everything over to it. I'm all set now. Thanks again. John Quote Link to comment
Vectorworks, Inc Employee Tamsin Slatter Posted November 2, 2011 Vectorworks, Inc Employee Share Posted November 2, 2011 Check View > Unified View Settings to see if you had turned it off there. Quote Link to comment
bc Posted November 2, 2011 Share Posted November 2, 2011 Tamsin, I go to View>Unified View Options and it isn't there. So where is the Unified View Settings? Quote Link to comment
Vectorworks, Inc Employee Tamsin Slatter Posted November 2, 2011 Vectorworks, Inc Employee Share Posted November 2, 2011 It's not there on 2012 anymore. But it was at 2010, which jgmrussell is using according to his signature. Quote Link to comment
jgmrussell Posted November 21, 2011 Author Share Posted November 21, 2011 Hi there, A late thank you. It was the unified view. Page boundary was not checked there. Take care and a Happy Thanksgiving. John Quote Link to comment
Vectorworks, Inc Employee Tamsin Slatter Posted November 21, 2011 Vectorworks, Inc Employee Share Posted November 21, 2011 You're welcome! Happy Thanksgiving to you too. Quote Link to comment
Tom G. Posted November 24, 2011 Share Posted November 24, 2011 (edited) Tamsin notes that the setting checkbox (to see it, dbl click on the Stacked Layers or Unified View icon) to show or don't show the page boundary on Design Layers is no longer accessible there in v.2012. Where has it been relocated to, or has it been fixed in place to always be visible or is it fully controlled by Page Setup? Tom Edited November 24, 2011 by Tom G. Quote Link to comment
Vectorworks, Inc Employee Tamsin Slatter Posted November 24, 2011 Vectorworks, Inc Employee Share Posted November 24, 2011 It's fully controlled by Page Setup - and you can now add it as a Quick Preference at the top right of your screen, so you turn it on and off with the click of a button. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.