vhector Posted September 21, 2011 Share Posted September 21, 2011 Often I need an angled end cap for a wall. Normally i draw another wall with the needed angle and T-joine the wall, after that I delete the angled wall so it leaves an angled end cap. This is when auto join is off in the preferences, with 'on' the wall repairs itself to a straight wall. But with drawing it is handy to have auto join on. Can i make a toggle of it instead of going continu to the preferences. Or is there another way for an angled end cap Vincent Quote Link to comment
vhector Posted September 21, 2011 Author Share Posted September 21, 2011 (edited) Found the toggle number '33'. SetPref(33, NOT GetPref(33)); Edited September 21, 2011 by vhector Quote Link to comment
Dieter @ DWorks Posted September 21, 2011 Share Posted September 21, 2011 You can also use the split tool (the knife icon). It's faster then your method of getting angled caps. Quote Link to comment
vhector Posted September 21, 2011 Author Share Posted September 21, 2011 Yes that's faster, thank you Quote Link to comment
D Wood Posted September 21, 2011 Share Posted September 21, 2011 You can also just draw a line across the wall at the angle you want, use the Trim tool and then delete the line. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.