Jump to content
Sign in to follow this  

Setting "Snap to working plane" on

Recommended Posts

During the use of a tool, I would like "Snap to working plane" to be set on. I found out that is was possible to set it on with

setConstrain('R'); but then I set all the other contraints off.

I would actually like to set everything back as it was before the use of the tool. But I cannot get their status.

I can get some of the snapping options as "Snap To Grid" with getpref, but not all of them

How can I do?


Share this post

Link to post

Try these Pref values. They should be available in VW 2010 SP4.

SnapToGrid = 37

SnapToObject = 38

SnapAngle = 470

SnapIntersect = 471

SnapSmartPoints = 472

SnapDistance = 473

SnapSmartEdge = 474

SnapConstrainTangent = 475

SnapConstrainToWorkingPlane = 476

SnapConstrainWorkingPlaneNormal = 477


Share this post

Link to post

Well, it does not allow to get the present snapping status. I guess it is just not possible in VW 2010 (in vectorscript)

Share this post

Link to post

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  


7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114


© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

  • Create New...