Stephen Sorenson Posted January 19, 2011 Share Posted January 19, 2011 I've noticed that in VW2011 I have to draw a fairly large selection box around the units to select them. I'm curious if this is a known issue, or if I'm alone, and if someone has a possible solution to this. I couldn't find anything else on the board about it here, but I'm not sure how many here are using 2011 yet. I'm using SP1 because of the accessory issue I ran into in SP2 (accessories not aligning themselves properly in 2d with the lights - my scrollers were about 18" to the left of the front of the unit and at about a 35? angle as an example- reverting to SP1 solved this issue for me). I tried it in the brief time I had SP2 installed and I had the same issue. Also tried with blank document. I'm using the new set of symbols that came with VW2011 (also my alterations of them - but for my test I just used the default VW ones). Any help would be appreciated. Quote Link to comment
sig_eigei Posted January 23, 2011 Share Posted January 23, 2011 You are not alone. It depends on the symbol. I notice this issue especially with some custom symbols I have made. I think it has to do with the label legend associated to the symbol but I am not sure yet. I'm still trying to figure it out. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.