Twickenhaman Posted January 11, 2011 Share Posted January 11, 2011 Hi, This has dogged me on this drawing. The red line shows the old wall which I made as a class. The class is switched on in both the Design layer and the Viewport but it will not show from one to the other without being an extrude. It was an adjustable polygon when drawn but would not register in viewport. I ticked both project planar and screen objects but it made no difference. I would just like to know the principle as to why it wont register. The file is 21 mg so I cannot send the original but a pdf Thank you once again regards David VW2010 Quote Link to comment
mike m oz Posted January 11, 2011 Share Posted January 11, 2011 Vw 2010 only supports 2D planar objects on the Layer Plane. To have your polygon show in 3D you will need to convert it to a 3D polygon or a nurbs curve. You could also model it as a wall or extrude with with no fill. Then you would see it as it actually is in your 3D views. Quote Link to comment
bcd Posted January 11, 2011 Share Posted January 11, 2011 Can you see it if you change the viewport to display Top/Plan? Quote Link to comment
Twickenhaman Posted January 11, 2011 Author Share Posted January 11, 2011 The view is in a viewport and as you can see from the enclosed pdf there is a plan view (viewport). It is not apparent here and I believe oz is correct that it can be seen in the elevation only because this red line is a 10mm extrude with no fill. Thanks for your help David Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.