tamarindi Posted December 17, 2010 Share Posted December 17, 2010 on sheet layer it looks smooth an clean on design layer looks bad with extra lines any suggestions? is it a bug? Quote Link to comment
CipesDesign Posted December 17, 2010 Share Posted December 17, 2010 Try... View>Rendering>Hidden Line Options> Set Smoothing angle to something other than zero.... Quote Link to comment
tamarindi Posted December 17, 2010 Author Share Posted December 17, 2010 Peter, It didn't affect the VP on the design layer. un-checking the "display objects beyond view plane" shows that the extra lines are from the windows. It looks like a bug. since section VP on sheet is ok.... Quote Link to comment
CipesDesign Posted December 17, 2010 Share Posted December 17, 2010 Hmmm. I played around with one of my files and found that Design Layer Section VP's will exhibit a lot of triangulated lines from windows and doors when in Wireframe, but the lines go away when the view is rendered. I have attached three screenshots: Wireframe, Hidden Line and Open GL. Although this *might* be a bug, it is more likely that it is working as designed and that the intent is that one of the render modes be used to view these SVP's... Quote Link to comment
tamarindi Posted December 18, 2010 Author Share Posted December 18, 2010 OK. got it. Section VP on sheet layer defines from design layer in the fact the you can't render only the VP. The control goes from rendering modes and not info pallet.It means you render the layer. But still.... it looks like cuts being made in the old cut command years ago... Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.