jarjones Posted June 30, 2010 Share Posted June 30, 2010 I have a document with the origin set to a specific point. When I view the file from the front/side/etc. the rulers on the side show measurements based on the 2d origin. Looking at the rulers, that point is 5'11.162 down from 0, so my floor is below zero compared to the rulers. If I make a new extrude however, it puts it on the floor at the correct relationship to the floor. How do I make my front view floor zero coordinate match my rulers? I'm back on VW 12 Thanks, Jeff Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.