Problems with animation walk through

[jimnilssonarchtects]

I have made a model (a long corridor) saved camera views at each end and an intermediate, I have then created a walk through animation using the three views. When I do a preview of the animation all looks fine but after hours of rendering and saving the video the result shows part of the view and a blank white area as though the rendering is only looking at two thirds of the saved view, one third being off camera.

Can anyone help please?

[grant_PD]

Most likely you ran out of memory and the rendering stopped.

[jimnilssonarchtects]

Thanks but I don?t think that is the problem as I have tried with the same model to do a very short ?walk? and kept all the settings at low levels to try experimenting. I still get the same problem as with the longer walk through. The camera is not pointing exactly at the saved view but off centre so that I do not see part of the view and am seeing a part of the rest of the page (blank) on the other side. The video goes to the end of the walk through but every frame is pointing off centre of the view.

I wonder if it is anything to do with the placement of the page. But I have tried setting both origin and page to the centre.

JIm

[islandmon]

Have you checked the XYZ+angle coordinates of the Camera ?