Jump to content

2D projections from a 3D Model


Recommended Posts

Hallo Leila,

I did some small edits on your File.

You already had a Viewport on a sheet layer. so I just copied it a couple of times and gave the Copies different Views and Render settings.

You could also add some Section Vewports if you like.

I'm not so shure, about the Render possibilities of Fundamentals, but The Line Render modes and Open GL should be part of your Sofware. (hopefully)

During editting I've recogniced, that your Extrudes had no fills. and that you were using open polylines for the 2d Profiles of the Extrudes

The Problem with open Polygons is, that you can't give them a fill, so when you render these object in Open GL there are just Lines, like in Wireframe, and the surfaces, are not shown.

I've modfied these open Polylines to closed Polygons using the Compose Command.

Enjoy.

Edited by Horst M.
Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...