Jump to content
Sign in to follow this  
Hen

Slope in 3D Landmark

Recommended Posts

Can anyone advise how I can extrude a slope so that is shows up in a 3D view? ie one end of the extrude needs to be higher than the other. It should look like the ramp from the side but solid.

Help!??

Thanks Hen

Share this post


Link to post

You might try switching to a front or side view, draw the profile, Model>Extrude > enter the width of the ramp.

hth

michaelk

Share this post


Link to post

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×