Lee Rose Posted March 27, 2010 Share Posted March 27, 2010 I've found an issue in numbering of multi-circuit lighting fixtures. When I built a Par bar of 6 and used it in a drawing, it will multi-circuit unit number in the A.1, A.2, A.3 or 1.A, 1.B, 1.C formats but will not unit number in the 1.1, 1.2, 1.3 format. Has anyone run into this? If so, have you seen a work around? Quote Link to comment
michaelk Posted March 28, 2010 Share Posted March 28, 2010 It works fine in 2010. 2009 has a hiccup. I set the position's multi circuit option to Num.Num and converted some PARs to multi circuit. I got the same result you got. However, after I switched the position multi option to AlphaNum and then Num.Alpha to confirm that both of those worked, I tried Num.Num and it worked! So try cycling thru the position multi options in the OIP. At least in my little test that is what worked. hth michaelk Quote Link to comment
Lee Rose Posted March 29, 2010 Author Share Posted March 29, 2010 Tried you suggestion, but it didn't work. Numbered fine as AlphaNum, but then was blank when I tried Num.Num. Quote Link to comment
michaelk Posted March 29, 2010 Share Posted March 29, 2010 I had to do AlphaNum, Num.Alpha, and then Num.Num Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.