BJS Posted August 31, 2009 Share Posted August 31, 2009 I haven't generally used trim on doors until recently. Now I want my exterior elevations to show the trim and I have noticed that when I turn the trim on it is almost always on the inside. Flipping the door changes the swing but not the side designated as interior or exterior. I have tried everything I can think of on this but can't figure out how to make sure doors have the "outside" facing out. Any thoughts? Quote Link to comment
kevin nicol design Posted August 31, 2009 Share Posted August 31, 2009 Hey In "Door Settings" click on "Parts" and then on the pull down menu, choose "Trim" and select "Include Exterior Trim" Should be fine... Cheers, KDB Quote Link to comment
Pat Stanford Posted August 31, 2009 Share Posted August 31, 2009 Remember that by default, VW assumes that you are going to draw the walls in a clockwise direction and that the Left side of the wall is the "external" side. If that is not how you drew the wall, then you need to select the wall and click the Reverse Sides button in the Object Info Palette. That should allow you to get your exterior trim on the outside of the wall. Quote Link to comment
BJS Posted September 1, 2009 Author Share Posted September 1, 2009 I knew VW was thinking something...I just wasn't sure what. Very helpful - thank you! Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.