botto Posted July 31, 2009 Share Posted July 31, 2009 Good Afternoon, How I can make a wall as in the figure? Thank?s very much, Pedro Botto Quote Link to comment
mike m oz Posted July 31, 2009 Share Posted July 31, 2009 There is a command that does this - the Fit Wall to Roof command. The bad news is that it doesn't exist in Landmark. Therefore you will have to reshape the top of the wall manually by adding vertices to approximate the curve using the 3D Reshape tool. Create a temporary guide by drawing the 2D curve in an elevation view and then extrude this and place it so it is over the top of the wall. Quote Link to comment
Jonathan Pickup Posted July 31, 2009 Share Posted July 31, 2009 if you didn't want the wall to be a real wall, you can model it in 3D Quote Link to comment
botto Posted August 3, 2009 Author Share Posted August 3, 2009 Thank?s a lot!!! Botto Quote Link to comment
Vectorworks, Inc Employee Tamsin Slatter Posted September 12, 2009 Vectorworks, Inc Employee Share Posted September 12, 2009 You can do this easily using the Wall tool and then editing with the Fillet Edge tool from the 3D palette. It will no longer be a "wall" but a generic solid. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.