Jump to content

Recommended Posts

When I use the create roof command, the roof in 3D appears well above the top of the walls. For example, if in Model Setup, I create a one story building without a basement, select "Use zero for the ground floor", select Default wall height as "Floor to floor", Mod-Floor 0 Elevation shows as 0", set Mod-Floor 0 Ceiling height at 8'-0", and Mod-Roof Elevation at 8"0", then when viewed in 3D the roof is floating about 8'-0" above the top of the wall. If I go back to Model Setup and set the Mod-Roof Elevation at 0", then the 3D view shows the roof floating about 8'-0" above a wall that has no height. Help. Thanks.

Link to comment

I would have replied sooner to thank all of you for the help, but I have been away from my computer. After reviewing all three suggestions, I changed my layer settings and the roof settled onto its rightful place on the walls. All now okay. Slowly the light is beginning to shin on my understanding of how 3D works in VectorWorks. Thanks for all of your help. Edward

Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...