Jump to content
Sign in to follow this  
michaelcobb

joining polylines

Recommended Posts

This may not be the best possible technique, but you can close each polyline using the checkbox in the info dialog box, add vertices if necessary to make the two intersect, then use the add surface tool to combine them into one surface. Turn off visibility of sides you don't want using the 2D reshape tool. (I assume that you meant to say you're using 8.5.2)

[This message has been edited by P Retondo (edited 06-23-2001).]

Share this post


Link to post

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×
×
  • Create New...