Mark Taylor Posted December 11, 2008 Share Posted December 11, 2008 I was tracing some boulders on a scan using a bezier curve and then filled the curve with the stock "sand" hatch. That worked fine until I cut and pasted the shapes to another layer. Now the shapes do not display the sand hatch even thought it still shows up in the attributes palette. When I choose a different hatch it shows up just fine. Is it possible I inadvertently erased the content of the sand hatch? Thanks, Mark Quote Link to comment
Ray Libby Posted December 11, 2008 Share Posted December 11, 2008 Could you post the file here? Quote Link to comment
Mark Taylor Posted December 17, 2008 Author Share Posted December 17, 2008 Hi Ray, How should I post the file? Should I save the drawing so that the view of those boulders is obvious and then post the .vwx file? Quote Link to comment
Ray Libby Posted December 17, 2008 Share Posted December 17, 2008 That would work. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.