Erik Buijs Posted February 9, 2004 Share Posted February 9, 2004 Hello, I am working on a 3D model and have the following question: I have the section of this model but the starting and ending angle of it is not the same. How can I create a model that is extruded and twisted around a centre line? Working with VW10.5 on PC Thanks for advice Quote Link to comment
Bart Rammeloo Posted February 9, 2004 Share Posted February 9, 2004 Construct both end profiles and use the loft tool. Or: extrude a profile and cut of the start and end. Cheers, BaRa Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.