I'd like to see additional setting options in roof creation tool.
In Sweden building codes statue building heights from three main parameters:
1. A maximum ridge height
2. A maximum exterior bearing height.
3. The roof pitch.
Eve heights or overhangs don't matter.
Interior bearings don't matter.
So my wish is obviously to be able to set pts 1 and 2 and to have the possibility not only to give them a value but also to set them as maximum values.
I.e either I determine the ridge height or I just set a max value that may not be exceeded.
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
bonus
I'd like to see additional setting options in roof creation tool.
In Sweden building codes statue building heights from three main parameters:
1. A maximum ridge height
2. A maximum exterior bearing height.
3. The roof pitch.
Eve heights or overhangs don't matter.
Interior bearings don't matter.
So my wish is obviously to be able to set pts 1 and 2 and to have the possibility not only to give them a value but also to set them as maximum values.
I.e either I determine the ridge height or I just set a max value that may not be exceeded.
Link to comment
0 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.