Jump to content

Hello Community!

This Thursday, October 21st, from 6 pm to 7 pm EDT, we will be performing an update on the Vectorworks Community Board. During this time, the site will be unavailable.

digital terrain modeling


Recommended Posts

A few things you may want to check:

Did your 3-d polys all have the correct z value after running 2-d contours to 3-d polys? Check by selecting 3-d polys and looking at the z value in the info palette. Also check to see if the range of z values match the range shown in the settings dialog box. If not you may need to change the scale of your 2d poly layer to more closely match the map you are tracing the contours from.

Do any of your 2-d contours cross? Run the DTM/check 3-d polys menu command to make sure.

Are some of the 3-d polys too close together? Run the filter 3d polygons tool to check.

These are a few things I check if a DTM does not work.

[This message has been edited by Marc Pitman (edited 04-01-2001).]

Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...