Guest Tomu Posted February 9, 2009 Share Posted February 9, 2009 Good point. The location of the pipe threads are not so obvious. The pipe threads, or more accurately, pipe taps, can be created using either of the following tools: Hole - Tapped (Inch) Hole - Tapped (Inch)-3D Hole - Tapped (Metric) Hole - Tapped (Metric)-3D The pipe sizes are listed at the end of the Screw Thread pop-up. The tools themselves are located on the Detailing tool set. Quote Link to comment
AndiACD Posted February 10, 2009 Author Share Posted February 10, 2009 Thanx Tom. i assume these would be the BSPT and BSPS in the UK versions of VW MD, for anyone on this side of the duck pond. Quote Link to comment
Guest Tomu Posted February 10, 2009 Share Posted February 10, 2009 Actually, BSPT and BSPS can be found in the Metric tapped holes. Quote Link to comment
AndiACD Posted February 11, 2009 Author Share Posted February 11, 2009 Right i'll peruse the inch Screw Threads too. Thanx Tom. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.