Window/Door Wall Splay

[portamigra]

I'm trying to splay walls in a few different ways.

1 - Is there a way to get the door jamb to automatically change to fit a splayed wall opening? Or do I have to manually set the thickness and offset the object (door/window)?

What I've found: It's a hassle, but it can be done.

2 - Is there a way to splay the wall above a door radially instead of just square while leaving the door square?

What I've found: seemingly can't be done w/out some intense 3d modeling.

3 - Can I splay the wall to the sides of an object while leaving the top and bottom 'flat?' For instance, to insert a lintel above the window, but to have a splayed wall under the lintel and stop at the sill.

What I've found: seemingly can't be done w/out some intense 3d modeling...again.

So, my scope on the splay tool is that it's way 'under-done' Works great for the little bit it can do.

I've read a lot of posts and nothing pertaining to 'splaying' in regard to these issues has come up. Is this a known bug? Is there no demand for such customization? If not, these are wish list items I guess...Thanks in advance!

[portamigra]

And just for the record, I do want a splay, I want 30 degrees, not a right angle.