Jump to content
Sign in to follow this  

Locking fixtures to a Truss Position.

Recommended Posts

I have run into another issue that I can not find a fix for. I have created drawing with multiple truss positions. Some of these trusses cross another. These truss positions are are each in their own class. As I attach a fixture to a truss, the position shows up in the object info window as it should. The problem happens when a fixture is attached with one truss position that is crossing another. The fixture will change positions if it touches a different position. This even happens when I turn off the unwanted position class. I try to type in the correct position in the object info window, but it reverts back to where it seem to think it should be. The end result is that the instrument schedule is incorrect. Any ideas?

Edited by kelrock

Share this post

Link to post

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  


7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114


© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

  • Create New...