Jump to content

Hello Community!

This Thursday, October 21st, from 6 pm to 7 pm EDT, we will be performing an update on the Vectorworks Community Board. During this time, the site will be unavailable.

Sheet layer viewports


Recommended Posts

New to the VW2008 upgrade. I have a sheet layer with a few view ports on it. The only way I can select a specific view port is to select the entire view port with a selection marquee. In 12.5, I was able to click anywhere on the view port to select it. Also, I'm not getting a move cursor with the selection tool when over the view port. What's happening here? Have I got a configuration problem?

Thanks,

Link to comment

I'm also new to 2008. SLVPs select normally in my system - cursor offers selection arrow when hovering over any snap point contained in the viewport. This obtains with all mode options of the 2d selection tool.

Sometimes VW2008 acts buggy. One example is selection/move options become ineffective during polyline edit in close zoom. I restart to fix. Relaunch VW does not always fix.

Good luck.

-B

Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...