lucylou Posted March 4, 2008 Share Posted March 4, 2008 Has anyone else notcied walls in VW2008 sp2 have started to act a little strange? they suddenly seem to automattically join to each other when you drag one onto another. this is fine, until you DONT want them to do it! have tried clicking the "enable connected walls mode" on and off as well as the "wall insertion mode". any ideas anyone? Thanks! Quote Link to comment
mike m oz Posted March 4, 2008 Share Posted March 4, 2008 If you don't want this behaviour uncheck the Auto join Walls option in the VectorWorks Preferences (Edit tab). Quote Link to comment
lucylou Posted March 4, 2008 Author Share Posted March 4, 2008 AH!!!!! thanks very much! have recently updated to SP2 and had to re-set all my preferences etc so that must be it! great! Quote Link to comment
Mitchell Posted March 19, 2008 Share Posted March 19, 2008 Has anyone had the problem of WALL TOOL not stretching parallel to itself once the ROTATE PLAN tool has been used to align the drawing to say a grid line that isnt 0 or 90deg to the wall? Any advice is much appreciated. Quote Link to comment
Mitchell Posted March 25, 2008 Share Posted March 25, 2008 All that was needed was the latest upgrade. The issue had already been addressed by VW. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.