Brooke Posted February 12, 2008 Share Posted February 12, 2008 (edited) Data like rough or masonry opening...I change and save it by clicking OK but values are not saved, though some others are like manufac and model. Perhaps the prog is second guessing me. Probably not a bad thing, but this time I'm looking at the manufac's data sheet. Edited February 12, 2008 by Brooke Quote Link to comment
Pat Stanford Posted February 12, 2008 Share Posted February 12, 2008 The Rough Opening, Masonry Opening and New Glazed area are calculated based on the other settings in the PIO. You can not change them manually. They are included in the data fields so they can be used easily in the Worksheet. The Rough Opening Width (I believe) is the door width + 2 x Jamb Width + 2 x Shim Gap. The Masonry Opening Width is the same thing, but rounded up to the Masonry Module. The same type of thing applies to the heights. If you want to change the openings, you will have to adjust the jamb and shim gap. Pat Quote Link to comment
Brooke Posted February 13, 2008 Author Share Posted February 13, 2008 (edited) I see. Thank you. Perhaps it is a recurring beef that input is accepted on such occasions but discarded without notice. The standard for such is to gray out and not accept data and it should be so here also, it seems. Edited February 13, 2008 by Brooke Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.