siewertdesign Posted September 6, 2000 Share Posted September 6, 2000 When printing to my hp 1220 i'm getting the "jaggies" on all polyilines and polygons. i've set the document prefs to 600 dpi, and the page setup to the same. one hint--even when i save and reopen the page setup it defaults back to 72 dpi. it's mac 233 system 8.1, vw 8.5. whatsup? ------------------ greg Quote Link to comment
siewertdesign Posted September 6, 2000 Author Share Posted September 6, 2000 ok, i got the newest driver (3.2) , and now it prints good!!!!! But, now when scaling a e size dwg down to page size in the page setup (25%), it only prints about 2/3 of the page???? is this a memory problem? stumped again, Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.