drawwhat? Posted September 17, 2007 Share Posted September 17, 2007 (edited) I don't know where they came from, but I have these 'dashed lines ' running horozontal & vertical from points at the drawing edge? in pairs - I have looked at the show/hide guide lines but they wont go away... What could they be? how do I get rid of them? n oH ya,, they run to infinity, and I can not select them seperate from the drawing. i can't select them at all... . they outomatically attach themselves to the pasted copy, and move with the selection, but realign when the drawing opens. and defy any attempt to 'trick' them into getting left out Edited September 17, 2007 by drawwhat? Quote Link to comment
Archeus Posted September 17, 2007 Share Posted September 17, 2007 Try turning off "Snap to loci" in VectorWorks preferences... Quote Link to comment
drawwhat? Posted September 17, 2007 Author Share Posted September 17, 2007 hi,, thanks,, no change. I de-selected all the constraints... no difference. Hummmmm Oh My ! In Preferences - That Did IT !!! Thank You So Much,,, it's disguise was it only happened to some drawings.. not all drawings. Quote Link to comment
jan15 Posted September 17, 2007 Share Posted September 17, 2007 ...only drawings that have loci in them. Quote Link to comment
drawwhat? Posted September 17, 2007 Author Share Posted September 17, 2007 Ah Ha! then that would be what I probably did then......... created some loci... and forgot. thanks again Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.