markdd Posted July 25, 2007 Share Posted July 25, 2007 This may have been discussed alot before, but I have searched and there is nothing on this forum as far as I can see...... I am starting to draw a square truss for a production I am working on. I do not use the truss tool much as my work is almost all theatre. Is there anyway of drawing realistic corner blocks with this tool or is it best to use the dxf files produced by the manufacturers? Any thoughts would be great!! Best Mark Quote Link to comment
Simon Carus-Wilson Posted July 25, 2007 Share Posted July 25, 2007 Mark. I would go with the manufacturers, however, you will need to convert the Imported Truss Corner into a 2d/3d Symbol otherwise things start disapearing. I went through this with kevin a while back, I believe this is the Thread http://techboard.nemetschek.net/ubbthreads/showflat.php?Cat=0&Number=62641&an=&page=0&vc=1 All the best. Simon Quote Link to comment
markdd Posted July 25, 2007 Author Share Posted July 25, 2007 Thanks for your reply.... At least I don't feel too much of an idiot for asking! The thread you quoted was one that I started a while back!!! Mark Quote Link to comment
Simon Carus-Wilson Posted July 25, 2007 Share Posted July 25, 2007 Sorry Mark. Try this one. http://techboard.nemetschek.net/ubbthreads/ubbthreads.php?ubb=showflat&Board=6&Number=6057&Searchpage=1&Main=1548&Words=&topic=0&Search=true#Post6057 Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.