Jump to content
Sign in to follow this  
Redune

Tubing in 3D

Recommended Posts

I am attempting to draft an electric car in 3D. It is constructed from 1" tubing. The tubes bend in several places, the bends are both horizontal and vertical planes. I am unable to draft this. I have attempted to extrude circles to create tubes of appropriate length, and rotating them to the right angle, but I cannot join them to form a continuous tube, also, the angle is at one point, wheras, on the car the bends are gradual, as would be formed by filleting a straight angle. How could I accomplish this properly ?

Share this post


Link to post

You may have to use a third party add-on such as MCnurbs or 3D Manager. Go to add on products page and check them out. Unfortunately they are not free.

Share this post


Link to post

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×
×
  • Create New...