Redune Posted March 7, 2000 Share Posted March 7, 2000 I am attempting to draft an electric car in 3D. It is constructed from 1" tubing. The tubes bend in several places, the bends are both horizontal and vertical planes. I am unable to draft this. I have attempted to extrude circles to create tubes of appropriate length, and rotating them to the right angle, but I cannot join them to form a continuous tube, also, the angle is at one point, wheras, on the car the bends are gradual, as would be formed by filleting a straight angle. How could I accomplish this properly ? Quote Link to comment
GeorgeH Posted March 7, 2000 Share Posted March 7, 2000 You may have to use a third party add-on such as MCnurbs or 3D Manager. Go to add on products page and check them out. Unfortunately they are not free. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.