Jump to content



Recommended Posts

When I clip a surface in VWorks, then extrude it, I end up with extra lines through the center of where I clipped it, which will only disappear when rendered 'shaded no lines'. Any idea how to avoid this? (assume making a tube- two concentric circles, clip surface, extrude, suddenly there is a tube that looks like it is made of two "C's" stuck together).

Link to comment

There is no way around this problem when using the clip surface command. You can take the two pieces that you are clipping and extrude them to the desired values. Then use the Subtract Solid command to take out the section you want. This will eliminate the line down the center.

Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...