Jump to content
  • 0
Sign in to follow this  
cacapis

Lines not thin enough

Question

Hi!

I was wondering how thin can vectorworks go. I've been trying to plot a lineweight of 1/16 pt. (about .025mm for you lucky metrics) but it looks the same or even thicker as 1/8 pt. (.05mm)

I'm using VW 12.5 on OS X 10.4 and trying the prints on a Epson Stylus C88, although I usually plot on an HP designjet 7550M.

I set the sheet and the print and pdf resolution to 300 dpi and quartz turned on.

I know the printer and plotter can go thinner than that because I've been able to do it with form-z.

Share this post


Link to post

0 answers to this question

Recommended Posts

There have been no answers to this question yet

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Answer this question...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×
×
  • Create New...