jeffroyer Posted April 17, 2007 Share Posted April 17, 2007 It would quite helpful if when editing an "extrude along path" profile one could snap to the center of the cross hair for accuracy sake. Quote Link to comment
0 P Retondo Posted April 18, 2007 Share Posted April 18, 2007 This would be very helpful. By the way, if you carefully place a locus at the apparent intersection of the axes, it will almost always appear at (0,0), and then you can snap to that. Quote Link to comment
0 jeffroyer Posted April 18, 2007 Author Share Posted April 18, 2007 Thanks for the tip! Quote Link to comment
0 propstuff Posted April 18, 2007 Share Posted April 18, 2007 This would be very helpful. By the way, if you carefully place a locus at the apparent intersection of the axes, it will almost always appear at (0,0), and then you can snap to that. If you double click the locus tool the default location is 0,0 and you can just hit enter. :-) Quote Link to comment
0 Guest Posted April 18, 2007 Share Posted April 18, 2007 added I usually do just as Nicholas suggests. Quote Link to comment
0 jeffroyer Posted April 18, 2007 Author Share Posted April 18, 2007 Thanks. That is a mighty nice change from what I have been doing! This must have been on the one page of the manual I didn't cover in my late night reading Quote Link to comment
Question
jeffroyer
It would quite helpful if when editing an "extrude along path" profile one could snap to the center of the cross hair for accuracy sake.
Link to comment
5 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.