Francois Levy Posted March 8, 2007 Share Posted March 8, 2007 I've recently had a few DTMs where the elevation labels are displaying as decimals (EG, 564'11.978" instead of 565'). This is in spite of the fact that the 3D poly corresponding to that contour has an exact Z of 565' in this case. Moving the 3D polys within the DTM up .022" does not change the display. I could set my display units to round to whole inches, but that obviously would sabotage the dimensioning everywhere else in my project file. I should also mention that I am using a cropping polygon in this DTM; don't know if that would contribute to this error. While I'm at it, there is no way, is there, to control the dislay units for a given DTM (EG displaying elevations as 565' instead of 565'0")? Quote Link to comment
islandmon Posted March 8, 2007 Share Posted March 8, 2007 Yes .. at creation the DTM inherits the Units preferences. If you require Feet instead of Feet&Inches, then select that preference and just redo the DTM procedure. Quote Link to comment
Francois Levy Posted March 12, 2007 Author Share Posted March 12, 2007 As I said, not so useful if the rest of one's file requires feet and inches. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.