Jump to content
Sign in to follow this  
grant_PD

cornerblocks? floor plates?

Recommended Posts

Floorplates, no. I make a symbol out of an extrude square, but coner blocks would be nice. Yes I can and do make symbols out of and extruded square, but when rendered it looks like a square, not a corner block.

Share this post


Link to post

I've been using a the truss tool to create corner blocks, by setting the length of the section to the width of the truss. Not perfect, but it looks closer in 3D than an extruded square.

Share this post


Link to post

I'd like to hear from everyone in this thread about needs they have for scenic / rigging details, symbols, content, etc. Email to randerson at nemetschek dot net. Thanks!

Share this post


Link to post

I usually do the same thing, make a short piece of truss, when I need a corner block.

For Tri-Truss I will use 2 pieces, ungroup them, and clip or delete the extra geometry.

Share this post


Link to post

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×
×
  • Create New...