Jump to content
  • 0
Sign in to follow this  
sjo76

12.0.1 Silent Installation

Question

I have tried doing a silent installation of VectorWorks 12.0.1 using the /s switch which works. However, the application is installed in evaluation mode and there doesn't seem to be a way to register it afterwards. I also tried to add the registry keys manually using regsvr32 but that didn't do the job. I was wondering is there a command line switch to specify the serial number, and any other relevant switches for that matter?

Share this post


Link to post

1 answer to this question

Recommended Posts

  • 0
Guest

There's no way to change an Eval install into a licensed install -- you have to re-run the installer and enter a serial number. The /s switch by-passes all dialogs, including the one where you enter the serial number, and thus can only do an Eval install.

Share this post


Link to post

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Answer this question...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×
×
  • Create New...