Kaare Baekgaard Posted September 12, 2006 Share Posted September 12, 2006 I downloaded the updater for 12.5 and installed it. Now I get the following message when I try to run the application: 'A VectorWorks dongle could not be found. Make sure that the dongle is connected and that all required drivers have been installed. VectorWorks will now quit.' Needless to say, the dongle is attached - has been all the time, the serial number is correct an I got no error messages while installing. Did I do anything wrong here? So now a days work will be lost... Please answer a bit fast, somone at NNA. Quote Link to comment
Kaare Baekgaard Posted September 12, 2006 Author Share Posted September 12, 2006 Found out to fix it myself. Go to http://www.aladdin.com/support/hasp/hasp4/enduser.asp Download the Hasp Installation. Run the installer as described. Quote Link to comment
marek.dk Posted September 12, 2006 Share Posted September 12, 2006 I experienced the same and could solve it by the hasp installation. thank you, kaare. Quote Link to comment
Kaare Baekgaard Posted September 12, 2006 Author Share Posted September 12, 2006 Well a days work is lost anyway - but not from the installation problems but from the EXCITING new possibilities :-o A special thanks for the HDRI and the Smooth Mesh function to everyone at the NNA! Quote Link to comment
Christiaan Posted September 12, 2006 Share Posted September 12, 2006 Download won't start for me Anyone able to share it? Quote Link to comment
marek.dk Posted September 12, 2006 Share Posted September 12, 2006 I can send it to you, if you give me your e-mail-adress. Quote Link to comment
Christiaan Posted September 12, 2006 Share Posted September 12, 2006 Thanks Marek, I've PM'd you my email address. (I also phoned Alladin headquarters and left a message with their website department, not that they're likely to understand my accent) Quote Link to comment
marek.dk Posted September 12, 2006 Share Posted September 12, 2006 have send it to you.. Quote Link to comment
Peter van der Elst Posted September 13, 2006 Share Posted September 13, 2006 Downloaded the new HASP Drivers, VW can find my dongle now, but it tells me my serial number is wrong. Any ideas? Is this a local (dutch) problem? Thanks! Regards, Peter Quote Link to comment
Guest Posted September 17, 2006 Share Posted September 17, 2006 Peter, If you are still having an install problem, send me the error message you receive along with your serial number to katie@nemetschek.net Quote Link to comment
Peter van der Elst Posted September 19, 2006 Share Posted September 19, 2006 Katie, Thanks, but it seems that our distibutor is working on an updated version. Our "US" version is somewhat different than yours. It seems there are also some German and French components in our version. Too bad I have to wait a little longer. Regards, Peter Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.