Have had to re-install VectorWorks 10.1 after a HDD failure. Re-installed VectorWorks 10.1 when I launch VectorWorks I get the following error message 'A VectorWorks dongle has been found but it does not match the one specified by your serial number. VectorWorks will now quit.'
I have tried the following:
Deleting the nemetschek folder references, delete the VW folder, and reinstalled.
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
adady
Have had to re-install VectorWorks 10.1 after a HDD failure. Re-installed VectorWorks 10.1 when I launch VectorWorks I get the following error message 'A VectorWorks dongle has been found but it does not match the one specified by your serial number. VectorWorks will now quit.'
I have tried the following:
Deleting the nemetschek folder references, delete the VW folder, and reinstalled.
but still get the above error message.
Thanks
Adrian
Link to comment
4 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.