You need to use Page Setup to establish your drawing size. Then go into VW>Page>Set Print Area. Select one page and your proper page size should be shown. In the diagram, only one box should be highlighted. If more than one box is highlighted, then try draging the box out and back into the upper left.
You most likely have letter size setup now and Acrobat is dividing up your drawing into letter size pieces.
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
Kevin
You need to use Page Setup to establish your drawing size. Then go into VW>Page>Set Print Area. Select one page and your proper page size should be shown. In the diagram, only one box should be highlighted. If more than one box is highlighted, then try draging the box out and back into the upper left.
You most likely have letter size setup now and Acrobat is dividing up your drawing into letter size pieces.
Link to comment
1 answer to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.