I have had Vectorworks 2012 for 13 years now but haven't used the program much for the past few years since (mostly) retiring. I recall being able to cut a 3D section thru a model. However, I cannot seem to recall how I did that. The Fundamentals Manual page 783 tells me to select the model then go to Model > Cut 3D Section on the tool menu. My Model dropdown menu does not show a Cut 3D Section selection. Is there an alternate method to do this? Thank you for any help.
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
John Horton
I have had Vectorworks 2012 for 13 years now but haven't used the program much for the past few years since (mostly) retiring. I recall being able to cut a 3D section thru a model. However, I cannot seem to recall how I did that. The Fundamentals Manual page 783 tells me to select the model then go to Model > Cut 3D Section on the tool menu. My Model dropdown menu does not show a Cut 3D Section selection. Is there an alternate method to do this? Thank you for any help.
Link to comment
0 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.