plotting with panther

[bob cleaver]

I cannot plot VW 10.5.1b files using panther (mac) on my HP designjet 800ps. Although an image prints, the sheet orientation does not register properly. I am using a custom sheet size to produce 24" x 36" sheets on the 24" wide plotter. The image that prints is a portion of the sheet. I have tried several configurations with no luck.

I tried HP in Boise and they know of the problem, but the guy I spoke with knew of no solution.

I really like panther's interface and wish to solve the problem.

Thank you in advance- Bob

[bob cleaver]

I was able to plot after using the preset drawing sizes (arch D) in page setup. The sheet is 37 3/8" long due to a hard margin HP adds to the sheet. My earlier solution was a cutom sheet size that is not a valid solution using panther.