michaelk Posted September 4, 2002 Share Posted September 4, 2002 I've noticed that VectorWorks Spotlight 9.5.3b1 is a little unstable when running OSX 10.2. I get "unexpected quits" occasionaly. (When are the "expected quits" supposed to happen?) I'm running a PowerBook G4, 256 ram, OS 10.2, VW 9.5.3b1. Anyone else having this problem? Quote Link to comment
slinkink Posted September 4, 2002 Share Posted September 4, 2002 i have an even worse problem. i cannot even install under os 10.2. has anyone else actually installed the application in os 10.2 as opposed to upgrading the os after spotlight was instaleed under an earlier os revision ? i get to the point in the installer where it sets up the dongle and that's it, the installer stops, i get a message saying there was an error and the installation was unsuccessful and i am taken back to the install screen. since the dongle bit is at the end of the install process, vectorworks spotlight has actually been installed but when i run it i can only get demo/no dongle mode. at the moment i am having to run spotlight in os 9.2.2 on an external drive and then email the files to myself to pick them up in 10.2 on my powerbook. absolute nightmare. the dongle driver update didn't seem to make any difference at all. help !!! Quote Link to comment
slinkink Posted September 4, 2002 Share Posted September 4, 2002 in case it is important i am on a pismo powerbook G3 500MHz with os 10.2 and 384Mb of ram. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.