G4-Altivec Posted April 21, 2002 Share Posted April 21, 2002 I've been using vector works for over 10 years and I still can't figure out an easy way to this. Basically what I want to do is create a flat ground plane for a building, however, I want it to be a 12" x 12" gridded mesh where I can then adjust each vertex to create contours. Its probably really simple but I just can't figure it out. Any help would be greatly appreciated. Quote Link to comment
Vectorworks, Inc Employee Biplab Posted April 22, 2002 Vectorworks, Inc Employee Share Posted April 22, 2002 I am going to explain 3D Power Pack way to do this: Create your ground plane by extruding a rectangle by 0 distance and convert the extrude to NURBS, thus creating a NURBS surface. Better yet, draw a rectangle and use Model->Create Surface from Curves to create a rectangular surface. Use the Create Contours tool to create a group of NURBS curves separated by a distance that you input. You can do this both in horizontal and vertical directions. You can ungroup the groups and with the NURBS curves selected, convert them to mesh or 3D Polys. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.