In order to improve the efficiency and the quality of the program I would like to call the attention of the NNA team on the following points:
1.- In the curved handrail show in the object palette; why when the RADIUS is equal or higher than the OVERALL ANGLE in a 3D view the horizontals rails keep straight?
Example:
A) Create a new document
B) Draw a curved handrail
C) OIP- OVERALL ANGLE type 10?
RADIUS type 60'
D) Change to 3D view (TOP)
Note: This happens for either VERY HIGH or LOW 3D
and 2D resolution.
2.- Why the ROUND WALL is not really a WALL?
The question is because the DUPLICATE SYMBOL IN WALL command doesn't work on ROUND WALLS. When we active the DUPLICATE SYMBOL IN WALL command warning message appears: "Pick a wall in wich to duplicate the active symbol".
3.- ATTACH HANDRAIL command doesn't work with the ramp command.
4.- Why on the OIP of the Door PIO both the door and the doorknob are related with the same command instead of being a command apart for each one.
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
JC
In order to improve the efficiency and the quality of the program I would like to call the attention of the NNA team on the following points:
1.- In the curved handrail show in the object palette; why when the RADIUS is equal or higher than the OVERALL ANGLE in a 3D view the horizontals rails keep straight?
Example:
A) Create a new document
B) Draw a curved handrail
C) OIP- OVERALL ANGLE type 10?
RADIUS type 60'
D) Change to 3D view (TOP)
Note: This happens for either VERY HIGH or LOW 3D
and 2D resolution.
2.- Why the ROUND WALL is not really a WALL?
The question is because the DUPLICATE SYMBOL IN WALL command doesn't work on ROUND WALLS. When we active the DUPLICATE SYMBOL IN WALL command warning message appears: "Pick a wall in wich to duplicate the active symbol".
3.- ATTACH HANDRAIL command doesn't work with the ramp command.
4.- Why on the OIP of the Door PIO both the door and the doorknob are related with the same command instead of being a command apart for each one.
Thanks in advance for your response.
VW 11.0.1 - MacOS 10.2.8 - G4 Dual 867 - 768 RAM
Link to comment
0 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.