RubenH Posted August 4, 2004 Share Posted August 4, 2004 Vectorworks preferences--> Edit --> Auto Join Walls (deselect it) [ 08-04-2004, 02:22 PM: Message edited by: RHF ] Quote Link to comment
0 Francois Levy Posted August 4, 2004 Author Share Posted August 4, 2004 My Autojoin pref is always off; that's not the problem unfortunately. Quote Link to comment
0 matto Posted August 4, 2004 Share Posted August 4, 2004 when you have the 2d selection tool enabled the last button on the bar will toogle the wall move mode on and off the P key is the deflaut shortcut when the 2d selection tool is enabled. Quote Link to comment
0 Francois Levy Posted August 4, 2004 Author Share Posted August 4, 2004 Yes, I know. My point is that it would be nice (for me at least) for that mode to be off when I launch the program, not on. Quote Link to comment
0 Francois Levy Posted August 5, 2004 Author Share Posted August 5, 2004 While sometimes it's nice to move one wall and have all attached walls move with it, most of the time I DON'T want that. It would be nice if that mode were turned off as the default. Quote Link to comment
Question
RubenH
Vectorworks preferences--> Edit --> Auto Join Walls (deselect it)
[ 08-04-2004, 02:22 PM: Message edited by: RHF ]
Link to comment
4 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.