ga 0 Posted February 20, 2004 is it ever possible to have 2 windows open on ne file like the way you can do it in microstation. it would be so useful whne drawing lines up from a plan to create a section Quote Share this post Link to post
0 Travis 0 Posted February 20, 2004 I generally handle this issue by showing the plan layer (sometimes "greyed out") beneath the section layer. Then I can actually snap to plan points. I've often temporarily enlarged the plan scale to the detail scale to make everything work a little faster. Just make sure you set the plan layer back to it's proper scale before printing. Regards, Travis [ 02-20-2004, 11:25 AM: Message edited by: Travis Tolman ] Quote Share this post Link to post
is it ever possible to have 2 windows open on ne file like the way you can do it in microstation.
it would be so useful whne drawing lines up from a plan to create a section
Share this post
Link to post